Call Back From

AXCBF 250D2-32
 

EQUIPMENT

 

AXCBF 250D2-32

  • Aerofoil blades with adjustable tilt angle
  • 1 ~ and 3 ~ -phase motors
  • The temperature of the transported medium is up to 200 ° C

Recommendations for application: The twin axial fans AXCBF of medium pressure are used to remove air with a temperature of up to 200 ° C in the ventilation systems of drying plants, the removal of hot gases from the production departments of metallurgical plants and boiler houses. Fans are produced with a rotor diameter from 250 to 800 mm.


Design: The fan casing is made of galvanized steel (hot galvanized by means of dipping, according to EN ISO 1461); impeller and vanes are made of cast aluminum. Flanges are made according to Eurovent 1/2.


Motor: The electric motor (1- and 3-phase) is taken out of the flow of transported air, completely isolated and cooled by a stream of air. Motor protection class IP55, insulation class F (according to EN 60034-5, IEC 85). For thermal protection, the motors are equipped with a built-in PTC thermistor for connection to an external protection device.


Speed regulation: The speed of a single-phase motor is regulated by means of transformers, the three-phase speed is controlled by a frequency converter.


Connection: The terminal box is mounted on the motor. Power to the fan is supplied by connecting the cable to the AC mains.

 

Mounting: The fan is connected to the duct network by means of flexible EVH inserts, mounted on the MFA supports, a protective grille of SG type is mounted on the air intake.


Certificates: Certificate of conformity of the Russian Federation and Ukraine.

 

CONTACTS

 

Sales Department

(048) 777-01-88

sales@ttg.com.ua

Project Department

(048) 777-02-88

project@ttg.com.ua

Technical support

(048) 728-30-51

support@ttg.com.ua

Service maintenance

(048) 777-01-88

service@ttg.com.ua